Energy Shield Sheathing features ACUltra Technology which means ZERO HCFC´s - a cost effective "Green" building solution. Excellent R-Values reduce energy demands while meeting or exceeding the Model Energy Code for your area, and also greatly reducing the potential for condensation problems. Energy Shield is a rigid polyiso foam board insulation with a triplex facer (foil-kraft-foil) on the topside and a trilaminate or solid foil facer on the unprinted back side.  R-Values & Thicknesses  Sheathing Typical Physical Properties

CODES & COMPLIANCES Energy Shield installed in a cavity wall complies with the requirements of the following building codes when properly installed: International Residential Code, Section 2603. (NER-449) Uniform Building Code, Section 2602. International Conference of Building Officials, Section 2603. BOCA Building Code, Section 2603. Standard Building Code, Section 2603. Federal Specification, HH-I-1972. ASTM C 1289 Standard for Polyiso Insulation. CCMC Evaluation Report, #12423-L (Meets CAN/CGSB 51.86-M86-Type 2) Miami-Dade Product Notice of Acceptance, Product Control No. 00-0208.04. California State Insulation Quality Standards and Title 25 Foam Flammability Criteria- #TC 1231 CAN/ULC S704-01, Type 2, Class C Spec this Product	RECOMMENDED USES Cavity Walls: Install thin profile Energy Shield, with its high R-value and moisture resistance, into the narrow cavities of masonry construction. Energy Shield is easily installed as the exterior wall is being constructed. The optional 16" and 24" widths fit between the masonry ties. Foundation/Under Slab installation of Energy Shield offers physical properties which make this rigid insulation ideal for foundation and under slab applications. Its resistance to moisture and decay, together with its ability to withstand loading and long-term thermal requirements, make Energy Shield Insulation a cost-effective solution to on-grade and below-grade insulation.
WARRANTY Manufacturer will replace at point of original destination within North America all material shown not to comply with manufacturer’s specifications. Atlas Roofing Corporation assumes no responsibility for building design or construction, which is solely the responsibility of the owner, architect, e Limited Warranty	INSTALLATION Energy Shield Cavity Wall General Installation Instructions Cavity Walls: Install thin profile Energy Shield, with its high R-value and moisture resistance, into the narrow cavities of masonry construction. Energy Shield is easily installed as the exterior wall is being constructed. The optional 16" and 24" widths fit between the masonry ties. Energy Shield is easily fabricated on the job. Block masonry walls’ efficiency can also be supplemented for greater thermal resistance by the installation of Energy Shield, on the interior or the exterior side.   Complete Instructions
STORAGE All sheathings should be stored with weather protection. If stored outdoors for any length of time, keep dry by covering completely with a waterproof tarpaulin. Store flat on pallets elevated at least 4" above the floor or ground and standing water.	SALES OFFICES Camp Hill Diboll East Moline LaGrange Phoenix Northglenn Toronto Sales Offices